1.50
For 10 points:
B3001 - Create Hem Unit system: IPS (inch, pound, second)
Decimal places: 2 Part origin: Arbitrary Material = Already
defined Sheet Metal Thickness: 0.125 inch Inner Bend Radius =
0.225 inch General K-Factor = 0.5
- Create a hem on the Sheet Metal part using the following
parameters:
Hem Type: Open Length: 1.00 inch Gap Distance: 0.125 inch
Custom Relief Type: Rectangular Relief Ratio: 0.50
-Measure the mass of the Sheet Metal part.
What is the mass of the Sheet Metal part (pounds)?
Enter Value:
I
(use. (point) as decimal separator)
Question 11 of 15
C1001 - Cutting Length - Outer Unit system: IPS (inch, pound,
second) Decimal places: 2 Part origin: Arbitrary Material =
Already defined Sheet Metal Thickness = Already defined Inner
Bend Radius = Already defined General K-Factor = Already
defined
- Download and open the attached part file.
NOTE: DO NOT modify any of the material properties of the
part.
- Using the Sheet Metal Cut List, measure the Outer Cutting
Length of the flat pattern.
Attachment to this question
Bạn đang xem 1. - SOLIDWORKS CSWPA SHEET METAL CERTIFICATION EXAM SET