99 84.99QUESTION 12 OF 15FOR 10 POINTS

99.99 84.99

Question 12 of 15

For 10 points:

C2001 - Gauge Table Import Unit system: IPS (inch, pound,

second) Decimal places: 2 Part origin: Arbitrary Material =

Already defined Sheet Metal Thickness = Already defined Inner

Bend Radius = Already defined General K-Factor = Already

defined

- Download the attached Gauge Table.

- Using the downloaded Gauge Table, apply it to the sheet metal

part downloaded in the previous question.

- Use the Gauge Table to apply the following parameters to the

Sheet Metal part:

Attachment to this question

@

bend allowance inches sample - English.xls (27.0 kB)

Enter Value:

(use. (point) as decimal separator)

Question 13 of 15

QtQ

C3001 - Inner Bend Radius Modification Unit system: IPS (inch,

pound, second) Decimal places: 2 Part origin: Arbitrary Material

= Already defined Sheet Metal Thickness = Already defined Inner

- Using the applied Gauge Table from the previous question,

modify the inner radius of the two bends circled in the image to

the following value:

Inner Radius: 0.5 inches (Gauge Table Value)

- Measure the Bounding Box Length.

- What is the Bounding Box Length (inches)?

Question 14 of 15

D1001 - Louver Placement Unit system: MMGS (millimeter,

gram, second) Decimal places: 2 Part origin: Already defined

Material = Already defined Sheet Metal Thickness = Already

defined Inner Bend Radius = Already defined General K-Factor =

Already defined

|-Download and open the attached zip file. It contains both a part

file "D.SLDPRT" and a forming tool "test_louver.SLDFTP".

-Place the forming tool in the proper folder of your Design

Library.