THE HIGHER THE BEARING LOAD, THE HIGHER THE VISCOSITY NEEDED TO FLO...
3. the higher the bearing load, the higher the viscosity needed to float the
journal at a given speed.
Of these statements:
(a) 1, 2 and 3 are correct
(b) 1 and 2 are correct
(c) 2 and 3 are correct
(d) 1 and 3 are correct
IAS-9Ans. (a)
IAS-10. Assertion
(A): An important feature of film lubrication is that once a lubricant film
is formed on the mating surfaces by running the bearing with a lubricant having a
high degree of oiliness, it is possible to change to a lubricant with a much lower
oiliness.
[IAS-1999]
Reason (R) Lubricants of high oiliness are liable to decompose or oxidize and hence
are not suitable for general lubrication purposes.
(a) Both A and R are individually true and R is the correct explanation of A
(b) Both A and R are individually true but R is not the correct explanation of A
(c) A is true but R is false
(d) A is false but R is true
IAS-10Ans. (a)
IAS-11. Thrust bearings of the sliding type are often provided with multiple
sector-shaped bearing pads of the tilting type instead of a continuous
angular bearing surface in order to
[IAS 1994]
(a) Distribute the thrust load more non-uniformly
(b) Provide limited adjustments to shaft misalignments
(c) Enable the formation of a wedge shaped oil film
(d) Enable lubricating oil to come into contact with the total bearing area
IAS-11 Ans. (c)
Hydrostatic Step Bearing 464IAS-12. The most suitable bearing for carrying very heavy loads with slow speed is
(a) Hydrodynamic bearing
(b) ball bearing
[IAS 1994]
(c) Roller bearing
(d) hydrostatic bearing
IAS-12 Ans. (d)
Comparison of Rolling and Sliding Contact bearingsIAS-13. Match List -I (Bearings) with List-II (Applications) and select the correct
answer using the codes given below the lists:
[IAS-1998]
List
–I
List-II
A. Journal bearing
1. Electric motors
B. Thrust bearing
2. Watches
C. Conical pivot bearing
3. Marineengines
D. Ball bearing
4. Swivelling chairs
Codes:
A
B
C
D
A
B
C
D
(a)
3
4
1
2
(b)
4
2
1
3
(c)
3
4
2
1
(d)
4
2
3
1
Design of Bearings
S K Mondal’s
Chapter 4
IAS-13Ans. (c)
Fluctuating Load Consideration for Design
S K Mondal’s
Chapter 5