0 192.168.0.2R2(CONFIG)# IP ROUTE 10.1.2.0 0 1...

255.255.255.0 192.168.0.2R2(config)# ip route 10.1.2.0 255.255.255.0 192.168.0.1When the engineer enters the show ip route command

on R1, the routing table does not display the static route to the 10.1.1.0 network. All R1 and R2 interfaces are correctly addressed per the

graphic. What is a logical next step that the engineer could take in order to make the static route display in the routing table in R1?

Enter default routes in R1 and R2.

***Enable the R1 and R2 serial interfaces.

Configure the static route to use an exit interface instead of a nexthop address.

Enter the copy run start command to force the router to recognize the configuration.